front diff

Got a tech question then post it up and someone may have the answer.

Moderator: Moderator Team

front diff

Postby jeepers » Sat Mar 01, 2008 7:21 pm

Gday,

Mate need some advice.Trying to remove the inner cv joints on the jackaroo but must be some kind of internal circlip,or something in the joint to remove them from the axel housing.Need to get the pricks out so i can drop the diff.Dont knowif your familiar with them or not but the diff ends or bolted a vertical bracket attached to the chassis frame.If i get the joints out i can drop the diff straight down without doing a contortionist act to lower the diff.Hope you can help.

cheers
User avatar
jeepers
TOURER
TOURER
 
Posts: 2114
Joined: Tue Dec 18, 2007 7:29 pm
Location: Newcastle

Postby Guest » Sun Mar 02, 2008 8:06 pm

sorry about the late reply, currently looking into it now. I'll get back on to the computer ASAP to let you know.
Guest
 

Postby jeepers » Mon Mar 03, 2008 6:32 am

cheers mate
User avatar
jeepers
TOURER
TOURER
 
Posts: 2114
Joined: Tue Dec 18, 2007 7:29 pm
Location: Newcastle

Postby tna racing » Tue Mar 04, 2008 10:48 pm

whats it on? solid axle or ifs?

im pritty sure ifs have circlips
User avatar
tna racing
BUSH BASHER
BUSH BASHER
 
Posts: 390
Joined: Mon Dec 31, 2007 2:47 pm

Postby jeepers » Wed Mar 05, 2008 7:19 pm

Ifs mate,wish it were a solid axle.
User avatar
jeepers
TOURER
TOURER
 
Posts: 2114
Joined: Tue Dec 18, 2007 7:29 pm
Location: Newcastle

Postby tna racing » Wed Mar 05, 2008 7:20 pm

should be a circlip then
User avatar
tna racing
BUSH BASHER
BUSH BASHER
 
Posts: 390
Joined: Mon Dec 31, 2007 2:47 pm

Postby Guest » Thu Mar 06, 2008 11:07 am

you haqve to disassamble the drive shafts first then remove the housing than disassamble the diff on the bench its the only way ring me later and ill tell you over the phone 0405137361
Guest
 

Postby jeepers » Thu Mar 06, 2008 6:51 pm

cheers mate had a feeling there was an internal circlip,will be all good knowing that thanks mate.
User avatar
jeepers
TOURER
TOURER
 
Posts: 2114
Joined: Tue Dec 18, 2007 7:29 pm
Location: Newcastle


Return to MECHANICAL WORKSHOP

Who is online

Users browsing this forum: No registered users and 1 guest

cron